reefer mod using ATU-Pro3

This is the post excerpt.

1.DISMANTLE AND REMOVE  ORIGINAL FLOAT ASSEMBLY

2.FIT NEW GLAND

3.THREAD WIRE END OF SENSOR FROM THE BOTTOM OF THE GLAND ENSURING WASHER IN POSITION

4.PULL SENSOR CABLE RIGHT THROUGH UNTIL SENSOR IN CORRECT POSITION AND TIGHTEN TOP OF GLAND

5.OPEN BLACK CONTROLLER AND ATTACH WIRES AS PER DIAGRAM

IMPORTANT: ENSURE THE WIRES are CORRECT

6.USING TYRAP SUPPLIED SECURE CABLE INSIDE CONTROLLER ON THE CABLE OUTER SLEEVING

Continue reading “reefer mod using ATU-Pro3”